MB - Spanish casing repair


WHO SAYS SPANISH CASINGS ARE STRONGER

On about start a job with a list to do, then see other things which appear and then appear again some where else. Now what fool keeps posting Spanish casings are the strongest you can get? Well they are not, in my opinion they are the weakest apart from a dodgy SIL casing which turns up now and then. This Spanish casing came with a list of work to be done for a custom bike. Grind and fill the neutral hole, fill in the brake inspection holes, remove the left over of the bump stop, repair where the rear brake adjuster has dug into the casing. Tune to suit the new RT kit but it's going to be a 240, weld and clean up a few dints. Weld and repair the cylinder stud hole, weld up a mag housing hole. Then as I'm working away I see a hidden crack in the mag to transfer joint the favorite crack zone of a Spanish casing and just when I think I'm finally done I see what I think is a crack near the engine number into the gear box area another weak spot of the casing. So I start to clean it up and I'm still not sure, I do my tricks to see the crack and I'm still not sure, I grind out and really I'm still not sure, so I then heat the casing and nothing appears until I start to MIG weld and I was right it was a crack, one only an expert can say is a crack verses a casting mark. As it turns out there was two hidden holes in the casting no wonder there was a crack. Finally around 6 hours later the casing is cleaned, welded, ground out, ground down, cleaned and polished ready for bead basting and powder coating. Again all in a days work, as for cost you could buy nearly two SIL casings for the time it took to repair this one.


This is very common on Spanish casings


Crank welded both sides


Mag gasket area always need milling flat due to distortion, we have fatter head gaskets to make up this machining


Inspection holes welded up


And from the other side


Neutral hole ground out and welded up


Another crank repaired


Engine bump stop removed and cleaned up, mag area cleaned to make the mag fit


Another crank welded and cleaned up


Damage welded and repaired


Now is that a crank? Oh yes


And welded up


And cleaned back


There's even damage from the rear brake adjuster which has been welded and repaired

Mark Broadhurst 2.3.2013 if you have any questions email mark@mbseriousoutdoors.co.uk